Installation instructions

  1. Disconnect the power cord from the old battery case
  2. Remove the battery compartment and its holder
  3. Connect the USB-C cable and the tap power cable to the TAPPOWER (NOTE! The tap power cable only goes one way - the flat part should be facing the back wall of the TAPPOWER)
    Make sure the cord is securely at the bottom (see picture below)
  4. Remove the protective paper from the back of the TAPPOWER tape.
  5. Attach TAPPOWER to the desired location
  6. Connect the USB cable to the power supply/plug

Route cables behind piping whenever possible.

When TAPPOWER supplies power to the faucet, depending on the model, the faucet should first show a red light and then a green light.

Note! The tap cable only goes one way, push the connector all the way in:


Test the operation.